Trying to match the circuit procedss diagrams to the schematic is tough as wire colors are different between the two. So if anyone has an updated schematic or can provide a detailed description of the harness plug, relay, and diode set-up, I'd appreciate it. Seems like there is no way for it to complete a circuit as wired. I have wired in accordance to the schematic and the stop switch is not working.
However the changes shematic shows a W wire from the relay and a W wire going to CS5 on tab 4 where diode2 starts. The step by step circuit diagrams show the w/y wire connecting to diode 2 on tab 4. The schematic shows the w/y wire comin from pin 8 of the harness (which has no lead attached to the harness side of the plug) goping to tab 3 of the solder tab where it connects to the w/y wire that goes to the slip wiper on the stop switch. This schematic has an error with the W/Y wiring that runs through the middle 4 tab soldering tab that includes diode2 and a resitor. I've ordered two manuals and both have the same schematic for the record changer mechanism. So first step is find out why the selector does not complete it's task, any suggestions? Also, any recommendations on where to find capacitors for the amp? Will certainly want to recap the amp down the line. I have inadvertantly jumped some terminals which caused the magagzine to spin and the record changer did a drop off and pick up, so that may be working.
The buttons work, but the selector just spins without stopping and never kicks in the magazine. The Cam that flips the record motor swirtch does not seem to ever end up over the motor switrch so the motor runs unless I manually turn the cam.ģ. If anyone has drawings or pictures that identify the various swirtches/sensors etc. I bought a manual which has OK schematics altough my manual seems to be missing some legends and names. I've recently picked up a Rowe mm5 and am attempting a rebuild.
0 kommentar(er)
